Fig. 6 – Top: Moving half TZM and Anviloy die inserts after 940 shots. TZM is in the bottom (left) position and Anviloy in the middle and upper positions. Electrical resistance heaters and thermocouple leads are visible on the lower edge of the mounting plate. Bottom: Close-up of Anviloy die inserts after 500 shoots.

Published at 754 × 1110 in Materials & Modifications to Die Cast the Copper Conductors of the Induction Motor Rotor

Fig. 6 – Top: Moving half TZM and Anviloy die inserts after 940 shots. TZM is in the bottom (left) position and Anviloy in the middle and upper positions. Electrical resistance heaters and thermocouple leads are visible on the lower edge of the mounting plate. Bottom: Close-up of Anviloy die inserts after 500 shoots.

Fig. 6 – Top: Moving half TZM and Anviloy die inserts after 940 shots. TZM is in the bottom (left) position and Anviloy in the middle and upper positions. Electrical resistance heaters and thermocouple leads are visible on the lower edge of the mounting plate. Bottom: Close-up of Anviloy die inserts after 500 shoots.

Fig. 6 – Top: Moving half TZM and Anviloy die inserts after 940 shots. TZM is in the bottom (left) position and Anviloy in the middle and upper positions. Electrical resistance heaters and thermocouple leads are visible on the lower edge of the mounting plate. Bottom: Close-up of Anviloy die inserts after 500 shoots.